TURN OFF POWER TO THE FIXTURES.

REMOVE LAMPS AND BALLAST COVER.

DISCONNECT BALLAST FROM POWER SUPPLY.

REMOVE AND DISCARD EXISTING SOCKET PLATE AND BALLAST IN ACCORDANCE WITH LOCAL CODES AND REQUIREMENTS.

INSTALL BALLAST BY SECURING TO THE TOP OF EXISTING HOUSING.  REMOVE SOCKET PLATES FROM MOUNTING BOX (DISCARD BOX).

SECURE SOCKET PLATES WITH "TEC" SCREWS SO THAT THE LAMPHOLDERS ARE AGAINST THE ENDS OF THE FIXTURE AND CENTERED LONGITUDINALLY

CONNECT BALLAST LEADS TO POWER SUPPLY ( ENSURE BALLAST IS GROUNDED TO FIXTURE).

NOTE: IF THE  INCOMING POWER IS END FED,  BEND CENTER TAB DOWN TO ALLOW ROOM FOR WIRES TO PASS.

SNAP R303 REFLECTOR INTO TABS LOCATED ON SOCKET PLATES.

CLEAN REFLECTOR, INSTALL LAMPS AND TURN ON POWER.